Troubleshooting - Kenmore 125.10701610 Manual De Uso

Review this table to find do-it-yourself solutions for minor performance problems. Any other
service needed should be performed by a qualified service agent.
WARNING
Always turn off and unplug vacuum cleaner before performing maintenance to the
vacuum cleaner. Failure to do so could result in electrical shock or personal injury.
PROBLEM
Vacuum cleaner won't
start.
Poor job of dirt
pick-up.
Vacuum cleaner starts
but shuts off.
Cord won't rewind.

TROUBLESHOOTING

POSSIBLE CAUSE
1. Unplugged at wall outlet.
2. Tripped circuit breaker/blown
fuse at household service panel.
1. Full or clogged dust bin.
2. Clogged airflow passages.
3. Dirty filters.
4. Hole in hose.
5. Dust bin open.
1. Tripped thermal protector
n i c n a t s i . r e
1. Dirty power cord.
2. Cord jammed.
1. Plug in firmly, push ON/OFF switch to on
(page 8).
2. Reset circuit breaker or replace fuse.
1. Empty dust bin (page 13).
2. Clear airflow passages (page 12).
3. Clean/Change filters (pages 14 - 17).
4. Replace hose.
5. Close dust bin until release button is
latched (page 13).
1. See PERFORMANCE FEATURES –
T "
1. Clean the power cord.
2. Pull out cord and rewind (page 8).
- 18 -
POSSIBLE SOLUTION
e h m r a P l t o r c e o t r" (page 11).