Brandt BFU584YNW Guía De Instalación Y Uso página 30

Reversing the door
The side at which the door opens can be
changed, from the
supplied) to the left
installation site requires.
Warning! When reversing the door, the
appliance must not be connected to the
mains. Ensure that the plug is removed
from the mains socket.
Tools you will need:
8mm socket
wrench
Thin-blade
screwdriver
Note: Before you
refrigerator on its back in order to gain
access to the base. You should rest it on
soft foam packaging or similar material
to avoid damaging the backboard of the
refrigerator. To reverse the door, the
following steps
recommended.
1. Stand the refrigerator upright. Open
the door to take out all door racks (to
avoid damaging the racks) and then
close the door.
2. Lift part ① from the top of the
refrigerator body from the right side
right side (as and then take down part ③ and part
side, if the ④ of the door in the same way. Take
down part ② and put it back into the
plastic bag.
Cross-shaped
screwdriver
8mm wrench
start, lay the
are generally
3. Disconnect electrical connector①
as well as electrical connector② and
then take down part③ .
4. Remove the screws ① , loose
wire② , and remove part③ .
9
① Upper cover
② Upper hinge cover (left)
③ Upper cover of upper door
④ Corner cover
1
2 3
1
2
3