Brandt BFU584YNW Guía De Instalación Y Uso página 31

① Special flange
self-tapping screws
② Earth wire
③ Upper hinge part
Note: Please hold the door by hand
during step 4 to prevent the door from
dropping.
5. Remove the door and place it on a
smooth surface with
upwards. Lever part① and part④ , then
loose screws② , as shown in
picture. Change handle③ to the right
side, then install screws② , part① and
part④ in turn. Loosen screws⑦ , detach
part⑥ and part⑤ , turn part ⑥ over and
then install part⑤ and part⑥ to the
left side with screws⑦ .
① Handle covers
② Special self-tapping screws
③ Handle
④ Screw hole covers
⑤ Door holder
1
⑥ Stop block
⑦ Self-tapping screws
2
1 2
6. Place refrigerator flatwise, remove
part③ and then loose screws④ .
Remove part ② and part① .
① Lower hinge part（left）
② Front foot fixed board
③ Adjustable bottom feet part
④ Self-tapping screws
7. Unscrew the lower hinge, change
it to the near hole site, and then
screw up and mount the washer.
8. Repeat step 6, change part① to
its panel left and part② to right and then fix
them with screws④ .
the
part③ .
Lower hinge part (right)
3
4
3
10
washer
Note: washer may
stick to the door.
Finally install