Maruyama BCF42HT Manual Del Propietário página 4

STOP SWITCH WIRING
Plug the stop switch wires into the matching connectors from the en-
gine. Note that wire polarity is not important. And bind the stop swich
wires with the clamp.
THROTTLE CABLE WIRING
The cable lug must be inserted into and through the cable adjuster
sleeve held by the bracket on top of the carburetor. Make sure the end
of the cable housing is seated positively in the sleeve. The cable lug
fits into the slotted fitting as shown.
A HOLE IS PROVIDED FOR THE LUG AT ONE END OF THE SLOT.
Operate the throttle trigger a few times to make sure that it works cor-
rectly. Adjust the cable adjuster sleeve so the stop on the carburetor
throttle cam just contacts the throttle stop when the throttle trigger is
depressed. When the throttle cable is adjusted correctly, tighten the
lock nut.
Clamp the throttle cable assembly with two bands as shown.
Caution! : This swivel stopper is exclusively for fixing the handle in
transport. Do not engage the swivel stopper while operating the brush-
cutter.
In transport and storage:
Tighten the wing nut, confirm the handle is fixed by the swivel stopper.
In operation:
Before start operation of the brushcutter, disengage the swivel stop-
per. Loosen the wing nut, confirm the handle becomes free to turn
around.
— US-3 —
Matching Connectors
Stop Switch Wires
Throttle Cable Housing
Cable Adjuster Sleeve
Lock Nut
Throttle Cable
Carburetor
Bracket
Shaft Assembly
Throttle Cable and
Band (2)
Stop Switch Wires
Wing Nut
Tighten
Slotted Fitting
Cable Lug
Recessed Hole
Loosen