List Of Alarms; Firmware Updating - Vimar Elvox SL24.W Guía Rápida Para El Instalador

SL24.W
List of signalling on the display
Signal Description
C1 Contact closed on command C1 input
C2 Contact closed on command C2 input
C3 Contact closed on command C3 input
C4 Contact closed on command C4 input
S1 Contact open on safety device S1 input
S2 Contact open on safety device S2 input
S3 Contact open on safety device S3 input
S4 Contact open on safety device S4 input
FO1 Opening limit switch position reached
FC1 Closing limit switch position reached
OBO Obstacle detected on opening
OBC Obstacle detected on closing
Motor in stop approach force reduction
AF1
interval
MSO1 Mechanical stop reached in opening
MSC1 Mechanical stop reached in closing
Operation with battery
When this message is displayed it is fol-
BATT
lowed by an indication of the battery oper-
ating voltage, e.g. 24.5V
Battery almost flat (indication shown only
BT-
when the gate is stopped)
Battery totally flat (indication shown only
BT--
when the gate is stopped)
Radio command received from saved re-
RX
mote control
Radio command received from unsaved
NX
remote control button
RD Rolling/fixed code decoding off
OAB Gate left open
AT Gate in self-calibration

List of alarms

Alarm Description
XXXX Reset card
Manoeuvre interval since last maintenance
MNP
reached alarm
F0 Error motor not selected
F1 Motor cables inverted error
F3 Reversed limit switch error
F4 Both open limit switch alarm
F5 Opening limit switch malfunction error
F6 Closing limit switch malfunction error
F9 Communication error with expansion card
F10 Error alarm motor not connected
F12 Encoder error alarm
Microswitch undervoltage (check power sup-
F14
ply and outputs)
F15 Safety test 1 failed
F16 Safety test 2 failed
24
F17 Safety test 3 failed
F18 Safety test 4 failed
F19 Manoeuvre length/timeout alarm
F21 Mosfet short alarm
F23 Blocked rotor alarm
F26 5th obstacle in closing alarm
F27 Overcurrent alarm
F29 Radio memory full alarm
F30 Faulty radio memory alarm
F31 Short flashing alarm
F32 Gate open light short alarm
F33 No memory card alarm
F34 FW checksum alarm

Firmware Updating

To update the control panel firmware, run the
following procedure
Step Description
Load the required firmware file on a USB mem-
1
ory stick
2 Disconnect the power supply to the control panel
Insert the USB memory stick in the USB connec-
3
tor on the control panel
4 Press buttons ESC and OK at the same time
Without releasing the buttons, power up the con-
5
trol panel
Keep pressing ESC and OK
6
7 After 3 s, the control panel displays PRG USB
8 Release the buttons
Press OK
9
Use buttons ▲ and▼ to select the required firm-
10 ware file to load. The file is displayed with the
firmware version
11 Press OK to confirm
12 The display shows "oooo" during programming
13 The display will show DONE. End of procedure
Press ESC. The LED on the display module will
14 start flashing. When it stops flashing, the card
reboots.
15 Remove the USB memory stick
EN