Swivel Clip Position When Placing Onto Vehicular Charger
The Vehicular Charger will accommodate for both swivel clips:
•
Standard swivel clip (PMLN6743_) – Any rotational position
•
D-ring swivel clip (42009312001) – Horizontal position
Rotate D-ring swivel clip to horizontal position before inserting the
WRSM or battery into the Vehicular Charger.
Figure 5.7: Swivel Clip Position
32
English
LED Light Indication
When troubleshooting, always observe the color of the LED.
Table 5.3: Charging Status
LED Indication
Steady Green
Steady Red
Charged successfully powered up and is ready
Single Flash Green
Slow Flash Green
Battery under voltage recovery
Battery temperature is either too hot or too cold
Slow Flash Amber
If battery temperature is within operating
temperature, there may be a fault connection
Charger State
Charged at least 95%
Rapid charge
for use
Nearly charged at least 90%
OR
– Wait to charge
– DO NOT charge battery