To Remove The Cover Plate; To Replace A Low And High Beam Lamp (P 525Dx Cabin); To Remove The Transmission Cover; To Replace The Headlights - Husqvarna P 520DX Manual De Usuario

To remove the cover plate

1. Remove the 2 screws and remove the cover plate.

To remove the transmission cover

1. Remove the 4 screws.
2. Lift and remove the transmission cover.

To replace the headlights

1. Remove the front cover of the steering column.
To remove and install the front cover of the
Refer to
steering column on page 29 .
2. Remove the 3 screws of the headlights.
1593 - 002 - 22.12.2020
3. Remove the headlights.
4. Assemble in opposite sequence.
To replace a low and high beam lamp (P
525DX Cabin)
1. Remove the 4 screws that hold the lamp module and
lift it out.
2. Disconnect the cables from the broken lamp.
3. Push the spring lock and remove the lamp.
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 56 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.
To replace a parking lamp
1. Remove the 4 screws that hold the lamp module and
lift it out.
2. Disconnect the cables from the broken lamp.
3. Remove the lamp.
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 56 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.
To replace a turn signal lamp
1. Remove the 4 screws that hold the lamp module and
lift it out.
2. Disconnect the cables from the broken lamp.
31