To Charge The 12 V Battery; To Replace The 12 V Battery; Troubleshooting - Husqvarna P 535HX Manual De Usuario

2. Loosen the nut to the belt tension spring.
3. Remove the belt.
4. Install the belt around the pulleys as shown in the
illustration.
5. Tighten the nut until the belt has the correct tension.

Troubleshooting

If you cannot find a solution to your problems in this
manual, speak to your Husqvarna service agent.
Problem
You can start the product, but
you cannot operate it.
56
50 N
15 mm / 0.6 in.
Troubleshooting
Cause
The temperature in the 48 V batteries is less than 0 °C/32 °F.

To charge the 12 V battery

Charge the battery if it is too weak to start the engine,
and during storage of the product.
1. Open the engine cover. Refer to
remove the engine cover on page 45 .
2. Turn the main switch to OFF.
3. Loosen the 2 screws to the air filter holder. Put the
air filter holder and the air filter to the side.
4. Remove the negative cable from the battery.
5. Remove the positive cable from the battery.
6. Use a standard battery charger to charge the
battery.
7. Install the cables and air filter holder in opposite
sequence.

To replace the 12 V battery

1. Disconnect the battery. Refer to
battery on page 56 .
2. Remove the 2 screws on the battery holder.
3. Lift the battery holder and remove the battery.
4. Replace the battery with a battery of the same type
and voltage.
5. Install the battery, battery holder and air filter in the
opposite sequence.
To open and
To charge the 12 V
1591 - 001 - 21.12.2020