3. Turn the lamp counterclockwise and remove the
lamp.
4. Put the new lamp into the lamp housing. Refer to
Technical data on page 56 .
5. Connect the cables to the new lamp.
6. Attach the lamp module and tighten the screws.
To replace the front work lights (P 525DX
Cabin)
1. Disconnect the cables from the broken lamp.
2. Turn the lamp counterclockwise and remove the
lamp.
3. Put the new lamp into the lamp housing. Refer to
Technical data on page 56 .
4. Connect the cables to the new lamp.
32
To replace the rear work lights (P 525DX
Cabin)
1. Disconnect the cable from the broken lamp.
2. Remove the screw on the lamp connector.
3. Remove the lamp connector with the lamp attached.
4. Install in the opposite sequence.
To replace the rear lights (P 525DX Cabin)
1. To replace the rear lights, contact an approved
service agent.
To replace the warning lights (P 525DX Cabin)
1. Loosen the wing nut.
2. Remove the lamp.
3. Attach the new lamp.
1593 - 002 - 22.12.2020