Assembly; To Attach The Cutting Deck Combi 132, Combi - Husqvarna P 520DX Manual De Usuario

• Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good condition.
• Do not change the adjustment of governors. If the
engine speed is too high, the product components
To attach the cutting deck Combi 132,
Combi 155
Note:
Make sure that the cutting deck and the product
are on level ground before you attach the cutting deck.
1. Put the lift lever to the position (B) to lower the lift
arms.
B
A
WARNING:
in the mow position (A). The force from
the lift spring can cause serious injury.
2. Carefully operate the product in front of the cutting
deck.
3. Put the lift arms into the joint of the cutting deck.
4. Apply the parking brake.
5. Stop the engine.
6. Install the bolts (C) and attach the pins (D) on the lift
arms.
C
D
1593 - 002 - 22.12.2020

Assembly

Do not put the lift lever
C
D
can become damaged. Refer to
page 56 for highest permitted engine speed.
• The product is approved only with the equipment
supplied or recommended by the manufacturer.
7. Remove the 2 screws and the service hatch.
8. Pull back the coupling of the drive shaft and attach
the drive shaft to the PTO.
Note:
Make sure that the arrow on the symbol
points to the product.
9. Put the rear lock chain around the lift beam.
10. Attach the lock chain to the drive shaft.
11. Pull back the coupling of the drive shaft and attach
the drive shaft to the bevel gear shaft of the cutting
deck.
Technical data on
15