Requirements For The Installation Location; Electric Connection - Graef Futura F 6 Manual De Instrucciones

Universal Slicer Futura F 6 / F 9
important!
If possible, save the original pack-
►
EN ing during the unit's warranty
period to be able to properly pack
the unit in case of a warranty
claim.
Requirements for the in-
stallation location
For safe and flawless operation of
the unit, the place of location must
meet these prerequisites:
The unit must be set up on a firm,
■
flat, level and non-slip base that
has sufficient load bearing capac-
ity.
Select the place of location so that
■
children cannot reach the sharp
blade in the unit.

Electric connection

Follow these instructions about the
electrical connection for safe and
flawless operation of the unit:
Before connecting the unit, com-
■
pare the connection information
(voltage and frequency) on the
rating plate with those of your
electrical network. This informa-
tion must match to avoid damage
to the unit. If in doubt, ask your
electrician.
Make sure that the connecting ca-
■
ble is not damaged. Do not con-
duct it over hot surfaces or sharp
edges.
■ The connector cable must not be
pulled tight.
20
The electrical safety of the unit
■
is only ensured if it is connected
to a properly installed protec-
tive conductor system. Operation
on a socket without a protec-
tive conductor is prohibited. If in
doubt, have the building instal-
lation checked by an electrician.
The manufacturer does not as-
sume any responsibility for dam-
ages caused by a missing or inter-
rupted protective conductor.