Remote Control - Dimplex VCX1525 El Manual Del Propietario

Operation
D. Top Light Dimmer Control
The top Top Light Dimmer Control
controls the brightness of the top
accent light that is used to illumi-
nate the pebbles.
Resetting The Temperature
Cutoff Switch
Should the heater overheat, an
automatic cut out will turn the fire-
place off and it will not come back
on without being reset. It can be
reset by switching the 3-Position
Switch to OFF and waiting five
minutes before switching the unit
back on.
CAUTION: If you need to
continuously reset the heater,
disconnect power and call
Dimplex customer service at
1-888-DIMPLEX
(1-888-346-7539).

Remote Control

The fireplace is supplied with an
integrated on/off remote control
!
NOTE: Ensure that the fire-
place 3-Position Switch is set
to the remote control setting.
To operate, push the ON button
to turn fireplace on, push the OFF
button to turn the fireplace off.
!
NOTE: Before attempting any
operation with the remote control,
pull the plastic insulator strip out
from between the remote casing
and battery cover.
Remote Control Initialization/
Reprogramming
15. Disconnect power to fire-
place.
16. Wait a minimum of 5 seconds
and then re-acquire power to
fireplace.
17. Within 10 seconds of re-
acquiring power, press the On
button located on the remote
control.
This will synchronize the remote
control and receiver.
Battery Replacement (Figure 11)
To replace the battery:
1. Slide battery cover open on
the remote control.
Figure 11
On
Button
Off
Button
Plastic
strip
Battery
cover
15