Operating Instructions - Master Forge 1010048 Manual De Instrucciones

OPERATING INSTRUCTIONS

Grill Lighting Instructions
To Light the Main Burner and the Side Burner
1. M ake sure the control knobs are in the "OFF" position.
2. Open the grill hood.
3. Check the ignition pin position and distance between the pin
and the burner.
4. Make sure the drip tray is installed.
5. Open the LPG tank or natural gas valve.
6. Light each burner separately. Turning on two burner valves
connection (LP grills only).
7. Push the control knob in and turn the knob to the left to "HIGH" position.
8. Push and turn burner control knob to "HIGH" and immediately press and hold
electronic igniter.
9. If the burner does not ignite, within 5 seconds immediately turn the control knob
back to the "OFF" position. Wait 5 minutes and repeat step 7 two or three times.
10. If the burner still does not ignite, TURN OFF THE GAS. WAIT 5 MINUTES
for excess gas to dissipate.
11. If the burner still can't be lit refer to the Troubleshooting section.
Replacing the battery
1. Unscrew the electrical ignition button and remove the old battery.
2. Replace with a new AA battery.
the side of the cap.
WARNING:
1. Make sue the hood is completely open each time you attempt to light the grill. Failure to
open the hood could lead to delayed ignition resulting in bodily harm.
CAUTION: It is important to inspect the full length of the gas line hose. If it is evident these is
excessive abrasion or wear, or the hose is cut, the hose must be replaced prior to the appli-
ance being used.
If required, check your parts list for the proper replacement hose assembly.
21
lowes.com/masterforge
®