Dash Disassembly; Kit Assembly; Din Radio Provision - Metra INST-5000 Instrucciones De Instalación

Dash Disassembly

All vehicles
1. Place your index fingers on the inner edges of the
A/C vents and push inward. (Figure A)
2. Grasp the exposed lip of each vent opening "A" and
pull out on the radio trim bezel. (Figure A)
3. Remove the dash trim bezel (airbag wiring does
NOT need to be disconnected). (Figure A)
4. Using Metra's 86-5618 or AW-FDRT, pull the
factory radio from the dash and disconnect
the wiring.
Continue to kit assembly
"A"
(Figure A)
1. Cut and remove the shaft supports from the
radio housing.
2. Slide the DIN cage into the housing and
secure by bending the metal locking tabs
down. (Figure A)
3. Slide the aftermarket radio into the cage
until secure. (Figure A)
4. Mount the rear support bracket to the back
of the radio with the necessary hardware.
(Figure B)
5. Locate the factory wiring harness in the
dash. Metra recommends using the proper
mating adapter from Metra or AXXESS. Re-
connect the negative battery terminal and
test the radio for proper operation.
6. Remove the top (2) Phillips screws securing
the climate control cluster to the sub-dash.
7. Slide the radio/kit assembly into the dash
cavity (be sure the rear support bracket
engages the support shelf in the dash).
8. Mount the bottom legs of the kit to the
same holes in the climate control cluster
with the (2) Phillips screws previously
removed. (Figure C)
9. Reassemble dash in reverse order
of disassembly.
5.1

Kit Assembly

DIN radio provision

(Figure A)
(Figure C)
(Figure B)