Publicidad
Idiomas disponibles
Idiomas disponibles
DIN radio provision:
1. Slide the DIN cage into the housing and secure by
bending the metal locking tabs down. Slide the
aftermarket radio into the cage until secure.
(Figure A)
2. If an equalizer will be included:
Slide the aftermarket equalizer into the back of the
Radio housing. Using the hardware included with
the equalizer, mount the equalizer to the kit.
(Figure B)
If an equalizer will NOT be included:
Snap the equalizer dummy plate onto the radio
housing. (Figure C)
3. Locate the factory wiring harness in the dash.
Metra recommends using the proper mating
adapter from Metra or AXXESS. Re-connect the
negative battery terminal and test the radio for
proper operation.
4. Mount the rear support bracket to the back of
the radio.
5. Mount the radio with kit assembly to the sub-dash
with (4) Phillips oval-head screws supplied (make
sure that the rear support bracket engages the
support shelf in the dash). (Figure D)
6. Reassemble dash in reverse order of disassembly.
Kit Assembly
All Vehicles
(Figure A)
(Figure B)
1.1
(Figure C)
(Figure D)
Publicidad
Capítulos
