GE GFDR485 Manual Del Propietario E Instalación página 32

Ocultar thumbs Ver también para GFDR485:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
Instructions
REVERSING THE DOOR SWING (if desired}
[!] REMOVE THE DOOR ASSEMBLY
A.
B.
Open the door to fully.
Remove 2 screws (#10 x 5/8") from the hinge,
starting
with the bottom screw. The door will tilt
away from the front panel, but will come to rest
in place.
C. Lift the door slightly and unhook if from the front
panel.
D. Place the door on a soft and flat surface.
[]
DISASSEMBLE THE DOOR ASSEMBLY
A. Place door on a soft and flat surface with the
inner door frame facing upward.
B. Remove 10 screws (#8 x 7/8") from the perimeter
of the door frame.
C. Separate the inner door frame from the chrome
door cover. Set the inner door frame aside on a
soft and flat surface.
[]
RE-LOCATE THE HINGE STRIKER AND
FRONT PANEL PLUGS
IMPORTANT: Note the location of the hinge (left or
right) before removing.
A. Remove 2 screws (#10 x 5/8") and front panel
plugs from the front panel.
B. Re-install front panel plugs and screws on
opposite side of the door opening.
C. Remove 2 screws (#8 x 1/2") and hinge striker
from the front panel.
D. Rotate hinge striker 180 degrees and re-install
with screws on the opposite side of the door
opening.
RE-LOCATE THE DOOR MASK
@
A. Place the chrome door cover on a soft and flat
surface so that the door mask is facing upwards.
B. Remove 2 screws (#8 x 1/2") that secure the door
mask in place.
C. Rotate the door mask 180 degrees and re-install
screws to secure door mask.
BEFORE
AFTER
D. Re-location
is complete. Set chrome door cover
aside.
32

Publicidad

Tabla de contenido
loading

Tabla de contenido