GE GFDR485 Manual Del Propietario E Instalación página 41

Before ou call for service... GEAppliances.co
PROBLEM
Clothes shrink
Passible Causes What To Do
Some fabrics will naturally shrink
when washed. Others can be
safely washed, but will shrink
in the dryer.
, To avoid shrinkage, follow garment care labels exactly.
. Some items may be pressed back into shape after drying.
If you are concerned about shrinkage in a particular
item, do not machine wash or tumble dry it.
Greasy spots on clothes Improper use of fabric softener • Follow directions on fabric softener package.
Drying dirty items , Use your dryer to dry only clean items. Dirty items can
with clean ones stain clean items and the dryer.
Clothes were not , Sometimes stains which cannot be seen when the
completely clean clothes are wet appear after drying. Use proper washing
procedures before drying.
Lint on clothes Lint filter is full , Clean lint screen before each load.
Improper sorting , Sort lint producers (likechenille)from lint collectors
(likecorduroy).
Static electricity can attract lint • See suggestions in this section under Static occurs.
Overloading • Separate large loads into smaller ones.
Paper, tissue, etc., left in pockets , Empty all pockets before laundering clothes.
Static occurs No fabric softener was used , Try a fabric softener.
e
Bounce®Fabric Conditioner Dryer Sheets have been
approved for use in all GEDryers when used in
accordance with the manufacturer's instructions.
Overdrying
Synthetics, permanent press
and blends can cause static
, Try a fabric softener.
, Adjust setting to Less Dry or Damp.
Try a fabric softener.
Collars and waistbands
still wet at end of cycle
The dryness monitor senses
that the body of the clothes
is dry
, Choose Speed Dry or Time Dry to dry damp collars
and waistbands. In the future, when drying a load with
collars and waistbands, choose More Dry.
Slight variation
in metallic color
This is normal
, Due to the metallic properties of paint used for this unique
product, slight variations of color may occur due to
viewing angles and lighting conditions.
Door is too foggy to see
clothes during a steam
cycle
Steam condenseson inner door , This is normal.
Water seen on inside of
door and top of lint filter
when opening door after
steam cycle
Steam condenses on these
surfaces
, This is normal.
Small areas on clothes are Steam condenseson inner drum , If using the Steam Dewrinkle cycle, manually reduce the
damp after steam cycle cycle time. If using the Steam Refresh cycle, add more
garments to the load.
41