Abicor Binzel ABIPLAS CUT 200 W Instructivo De Servicio página 24

EN Translation of the original operating instructions
© The manufacturer reserves the right, at any time and without prior notice, to make such changes
and amendments to these operating instructions as become necessary due to misprints, inaccuracies
or product enhancements. Such changes will, however, be incorporated into subsequent editions of
the operating instructions.
All brand names and trademarks that appear in these operating instructions are the property of their
respective owners/manufacturers.
Our latest product documents as well as all contact details for the ABICOR BINZEL national
subsidiaries and partners worldwide can be found on our website at www.binzel-abicor.com
1 Identification
1.1 Marking
2 Safety
2.1 Designated use
2.2 Personal protective equipment
(PPE)
2.3 Classification of the warnings
2.4 Special warnings for operation
2.5 Emergency information
3 Product description
3.1 Technical data
3.2 Abbreviations
3.3 Signs and symbols used
3.4 Nameplate
4 Scope of delivery
5 Functional description
6 Putting into operation
6.1 Setting up the manual cutting
torch
6.1.1 Accessories
6.2 Connecting the plasma cutting
torch
EN - 2
EN-3 6.3
EN-3 6.3.1 Compressed air for plasma gas EN-14
6.3.2 Filtered compressed air free of
EN-3
EN-3 6.3.3 Plasma cutting torch with a central
EN-3
EN-3 7
EN-4 7.1
EN-4 7.2
EN-4 7.3
EN-5 7.4
EN-7
EN-8 8
EN-8
9
EN-8
10
EN-9
11
EN-9
EN-10
EN-11
EN-13
®
ABIPLAS CUT 200 W/MT
Connecting the coolant
oil and water
connector
Operation
Before switching on
Trigger with dual-cycle function
(for manual torches only)
Safety device
Igniting the torch
Putting out of operation
Maintenance and cleaning EN-18
Troubleshooting
Disposal
BAL.0120 • 2019-01-03
EN-13
EN-14
EN-15
EN-15
EN-16
EN-16
EN-16
EN-17
EN-17
EN-20
EN-21