Igniting The Torch; Putting Out Of Operation - Abicor Binzel ABIPLAS CUT 200 W Instructivo De Servicio

®
ABIPLAS CUT 200 W/MT

7.4 Igniting the torch

WARNING
Arc eye
The arc produced by welding can damage the eyes.
• Check and wear your personal protective equipment.
NOTICE
• Consult the documentation for the welding components.
• Check the actual gas flow on the measuring instruments or by closing and opening the
corresponding gas outlet openings on the torch.
• All necessary parameters (such as the cutting current, soft start, compressed air etc.) must
be set on the power source in accordance with the cutting operation.
• Information and tips on the direct cutting process (technique, procedure, materials,
plasma...) can be found in the relevant technical literature.
1 Open the compressed air valve.
2 Switch on the power source.
3 Press the trigger on the handle. After the initial gas flow period, the pilot arc is ignited by
high-frequency pulses.
4 Pass the torch directly over the workpiece; the cutting arc will develop.
5 The cutting arc is interrupted as soon as contact with the workpiece is lost.
NOTICE
• Please observe the required gas post-flow time for cooling the torch.
• When starting the pilot arc, the cutting nozzle must not be in contact with the workpiece.
• The cutting arc is ignited on the workpiece. The cutting beam is interrupted as soon as
contact with the workpiece is lost.

8 Putting out of operation

NOTICE
• Consult the documentation for the welding components.
1 Close the compressed air valve.
2 Switch off the power source.
BAL.0120 • 2019-01-03
8 Putting out of operation
EN - 17