Abicor Binzel ABIPLAS CUT 200 W Instructivo De Servicio página 33

®
ABIPLAS CUT 200 W/MT
NOTICE
• Fastening on the protective cap too tightly can damage the insulator and the swirl ring.
Fastening it on too loosely shortens the service life of the wear parts.
• Please ensure that the swirl ring is correctly positioned. The air holes should always point
towards the electrode tip.
• The plasma cutting torches are equipped with a safety shut-off mechanism for the
operator's protection. This automatically interrupts the inrush current circuit if the
protective cap is removed. Two spring-mounted contact pins are actuated when the
protective cap is screwed on. If the spring effect of the contact pins is impeded, the safety
shut-off mechanism can become ineffective.
• Ensure that all contact surfaces between the spring-mounted contact pins and the contact
ring on the protective cap are kept clean.
• Disconnect the plasma power source when replacing wear parts.
1 Screw in the insulator and hand-tighten.
2 Attach the electrode.
3 Attach the swirl ring.
4 Attach the selected plasma nozzle.
The choice of plasma nozzle is determined by the thickness of the material to be cut and the
current intensity.
 Tab. 5 Selection of plasma nozzle on page EN-6
5 Hand-tighten the protective cap.
6.1.1 Accessories
Circular torch guide set
• Circular parts with a diameter of approx. 100 to 1,000 mm can be cut with the
ABIPLAS
• The torch carriage is clamped to the protective cap.
NOTICE
• When tightening the set screw to clamp the torch carriage into place, ensure that the
protective cap is not subject to excessive pressure, damaging the inside thread.
Fig. 3
BAL.0120 • 2019-01-03
®
CUT 200 W manual torch by using a circular torch guide.
®
ABIPLAS CUT 200 W circular torch guide
6 Putting into operation
EN - 11