Connecting The Plasma Cutting Torch; Connecting The Coolant; Risk Of Burns - Abicor Binzel ABIPLAS CUT 200 W Instructivo De Servicio

®
ABIPLAS CUT 200 W/MT
Fig. 5

6.2 Connecting the plasma cutting torch

NOTICE
• Make sure the connections are properly assigned and tightened.
• Since the plasma nozzle cannot be protected against direct contact for technical reasons,
the plasma cutting power source must fulfil the requirements of EN 60974-7, point 7.4.2.
• When used with the plasma power source, the plasma cutting torch must conform to
EN 60974-10.
• The plasma power source must also conform to EN 60974-1.
• The plasma power source and cutting torch must have the same type of ignition (contact
or HF) and the same output power (rated current and corresponding duty cycle).
 Tab. 3 Product-specific torch data (EN 60974-7) on page EN-5

6.3 Connecting the coolant

WARNING

Risk of burns

If the coolant level is too low, the plasma cutting torches will overheat.
• Wear the correct protective gloves.
• Check the coolant level at regular intervals.
NOTICE
• Ensure that the coolant supply and return hoses have been correctly installed. Coolant
supply = blue, coolant return = red.
• Do not use deionised or demineralised water as coolant or for leak and flow tests.
This may shorten your welding torch's service life.
• For liquid-cooled cutting torches, we recommend using ABICOR BINZEL BTC coolant.
 Please consult the applicable safety data sheet.
BAL.0120 • 2019-01-03
Mount for the machine cutting torch
6 Putting into operation
EN - 13