Installation Place
Requirements
When installing the appliance, check the
following information to make sure that the
appliance is installed in a correct place.
Installation Location
• Install the appliance on a flat hard floor.
(Allowable slope under the appliance: 1°)
• Never try to correct any unevenness in the
floor with pieces of wood, cardboard or similar
materials under the appliance.
• If it is impossible to avoid positioning the
appliance next to a gas cooker or coal burning
stove, an insulation (850x600 mm) covered
with aluminum foil on the side facing the
cooker or stove must be inserted between the
two appliances.
• Ensure that when the appliance is installed, it
is easily accessible for an engineer in the event
of a breakdown.
• With the appliance installed, adjust all four
feet using the transit bolt spanner provided to
ensure the appliance is stable, and a clearance
of approximately 5 mm is left between the
top of the appliance and the underside of any
worktop.
• Additional clearance should have
100 mm for the wall and 20 mm for rear, right
and left side.
• This appliance must only be used for domestic
NOTE
• If the washing machine is installed on a raised
Wooden Floors (Suspended
Floors)
When installing the appliance on wooden floors,
use rubber cups to prevent the appliance from
excessive vibration and unbalance.
• To prevent vibration we recommend you place
100 mm
INSTALLATION
20 mm
20 mm
WARNING
household purposes and should not be used in
mobile applications.
platform, it must be securely fastened in order
to eliminate the risk of falling off.
rubber cups (
) at least 15 mm thick of the
1
each foot of the appliance, secured to at least
two floor beams with screws.
11
EN
5 mm