Leveling The Appliance - LG WM20WV26 Manual Del Propietário

Removing the Bolt Assemblies
• Starting with the bottom two transit bolts
( ), use the spanner (included) to fully
3
loosen all transit bolts by turning them
counterclockwise. Remove the bolt assemblies
by wiggling them slightly while pulling them
out.
Installing the Hole Caps
• Locate the hole caps (
accessory pack or attached on the back.
NOTE
• (*) : This feature varies depending on the
model purchased.
• Save the bolt assemblies for future use. To
prevent damage to internal components, do
not transport the washing machine without
reinstalling the transit bolts.
• Failure to remove transit bolts and retainers
may cause severe vibration and noise, which
can lead to permanent damage to the washing
machine. The cord is secured to the back of
the washing machine with a transit bolt to help
prevent operation with transit bolts in place.
) included in the
4

Leveling the Appliance

Checking Leveling
When pushing down the adges of the appliance
top plate diagnally, the appliance should not move
up and down at all (check both directions). If the
appliance rocks when pushing the appliance top
plate diagnally, adjust the feet again.
Adjusting Leveling Feet
When installing the appliance, the appliance
should be aligned and perfectly level. If the
appliance is not aligned and level properly, the
appliance may be damaged or may not operate
properly.
1.
Turn the adjustable feet as required if the
floor is uneven.
• Do not insert pieces of wood etc. under the
feet.
• Make sure that all four feet are stable and
resting on the floor.
Raise
Lower
13 EN
INSTALLATION