Iso Din Radio Provision With Pocket - Metra 99-5026 Instrucciones De Instalación

1. Snap the trim plate into the radio housing.
Attach the ISO brackets to the inner lip of
the housing. (Figure A)
2. Slide the radio/bracket assembly into the
radio opening and align the holes in the
radio with the holes in the ISO brackets and
mount the radio to the brackets with the
screws supplied with the radio. (Figure B)
3. Thread the rear support bracket onto the
back of the radio (or cage) and secure with
the mounting nut supplied. (Figure C)
Note: Navigator DIN and ISO radio kit
assemblies, you must cut the rear support
bracket for clearance. (Figure D)
4. Locate the factory wiring harness in the
dash. Metra recommends using the proper
mating adapter from Metra or AXXESS. Re-
connect the negative battery terminal and
test the radio for proper operation.
5. Reassemble dash in reverse order of
disassembly.
Kit Assembly 99-5026

ISO DIN radio provision with pocket

(Figure A)
(Figure B)
(Figure C)
(Figure D)
6
Rear view radio
REAR VIEW HEAD UNIT
REAR SUPPORT BRACKET
Rear support bracket