Kit Assembly; Din Radio Provision With Pocket; Iso Din Radio Provision With Pocket - Metra 99-7428 Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

DIN radio provision with pocket

1. Remove the metal DIN sleeve from
the aftermarket radio.
2. Slide the sleeve into the radio
housing and secure by bending
the metal locking tabs outward.
(Figure A)
3. Slide the radio into the sleeve until
it snaps into place. (Figure B)
4. Snap the pocket into the bottom
opening of the radio housing.
(Figure C)
5.
Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio and climate controls. Metra
recommends using the proper mating
adapter from Metra and/or AXXESS. Re-
connect the negative battery terminal
and test the radio for proper operation.
6. Reassemble the dash in reverse
order of disassembly.

Kit Assembly

(Figure A)
(Figure B)
(Figure C)
99-7428

ISO DIN radio provision with pocket

1. Remove the metal DIN sleeve and
trim ring from the aftermarket radio.
2. Mount the ISO brackets to the
radio using the screws supplied
with the radio. (Figure A)
3. Slide the radio into the radio housing
until it snaps into place. (Figure B)
4. Snap the ISO trim plate onto the
front of the radio housing. (Figure B)
5. Snap the pocket into the bottom
opening of the radio housing.
(Figure C)
6.
Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio and climate controls. Metra
recommends using the proper mating
adapter from Metra and/or AXXESS. Re-
connect the negative battery terminal
and test the radio for proper operation.
7. Reassemble the dash in reverse
order of disassembly.
3
(Figure A)
(Figure B)
(Figure C)

Publicidad

Tabla de contenido
loading

Tabla de contenido