Iso Din Radio Provision With Pocket - Metra 99-7610 Instrucciones De Instalación

Note: The following modification will need
to be made to both ISO brackets when using
the ISO radio provision. Cut or trim the area
shown from the ISO bracket. (Figure A)
1. Cut and remove the appropriate tabs not
necessary for your application. (Figure B)
2. Remove the metal "DIN" sleeve and trim
ring from the aftermarket radio.
3. Mount the ISO Brackets to the
aftermarket radio with the screws
supplied with the radio. (Figure C)
4. Slide the radio into the radio opening
until the side clips engage. (Figure D)
5. Locate the factory wiring harness
and antenna plug in the dash. Metra
recommends using the proper mating
adapters from Metra and/or AXXESS.
6. Attach the trim plate supplied with the
kit to the front of the radio housing
assembly. (Figure D)
7. Reassemble the dash in reverse order
of disassembly.
Kit Assembly 99-7610

ISO DIN radio provision with pocket

Front face,
FRONT
right side
FACE-
bracket
RIGHT
SIDE
BRACKET
(Figure A)
FRONT
FACE-
Nissan Juke
RIGHT
SIDE
BRACKET
Nissan Versa
Nissan Juke
(Figure B)
(Figure C)
(Figure D)
5
Right side clip