Stacked Iso Mount Unit Provision - Metra 99-7423 Instrucciones De Instalación

Stacked ISO mount unit provision

1. Cut and remove the center bar from the
radio housing assembly. (Figure A)
2. Snap the Double DIN brackets to
the inside edge of the radio housing
assembly. (Figure B)
3. Slide the stacked ISO units into the
bracket/radio housing assembly and
secure the units to the kit using the
screws supplied with the units.
(Figure C)
4. Snap the Double DIN trim plate onto
the front of the radio/housing assembly.
(Figure C)
5. Locate the factory wiring harness in the
dash. Metra recommends using the
proper mating adapter from Metra or
AXXESS. Re-connect the negative
battery terminal and test the unit for
proper operation.
6. Reassemble dash in reverse order
of disassembly.
Kit Assembly 99-7423
8
(Figure A)
(Figure B)
(Figure C)