STACKED ISO MOUNT UNITS PROVISION
*
Note: Refer also to the instructions included with the aftermarket radio.
1 For the 2007 Ford Edge/Expedition,
2006-07 Explorer/Fusion/
Mercury Milan, 2004-07 F-150,
2005-07 Five Hundred/
Freestyle/Mustang/Mercury
Montego, 2005-07 Lincoln Mark LT
and the 2008 Ford Super Duty, cut
and remove the rear mounting tabs
from the Double DIN Brackets.
a. If your vehicle is not listed above
move to step 2.
2
For the 2007 Ford Edge/Expedition,
2006-07 Ford Explorer, 2006-07
Ford Fusion, 2007 Mustang and
the 2008 Super Duty attach the
included spacers to the back of the
radio housing mounting tabs.
(Figure A)
a. If your vehicle is not listed above
move to step 3.
NOTE: Use the screws supplied with this
kit to mount the radio housing in the
vehicles that require the spacers.
3
Attach the double DIN brackets to the
radio housing. Note: The notch in the
housing should be on top.
(Figure 3A,3B)
4
Slide the ISO mount units into the
radio housing/bracket assembly and
secure the units to the assembly using
the screws supplied with the units.
(Figure C)
Continue to kit assembly.
99-5815 KIT ASSEMBL Y
3B
18
A
3A
C