Dash Disassembly; Chevrolet Astro/Gmc Safari 1996-2005; Gmc Savana 1996-2000 - Metra 99-3002 Instrucciones De Instalación

Chevrolet Express/GMC
Savana 1996-2000
1. Unclip the plastic trim piece located below the
steering column.
2. Unclip the dash trim bezel.
3. Pull the bezel over the steering column and
disconnect the wiring. Using a flat-blade
screwdriver, press down on the outside clips of the
factory radio and remove. (Figure A)
4. Peel away the paper backings from the tape strips
and stick the strips to the lower shelves of the
mounting clips. (Figure B)
Continue to kit assembly
(Figure A) (Figure B)

Dash Disassembly

Chevrolet Astro/GMC
Safari 1996-2005
1. Place the gear selector in its lowest position.
2. Unclip the perimeter of the dash trim bezel.
3. Disconnect the rear A/C control harness and the
headlight switch from the back of the dash trim
bezel and remove the bezel. Using a flat-blade
screwdriver, press down on the outside clips of the
factory radio and remove. (Figure A)
4.
Peel away the paper backings from the tape strips
and stick the strips to the lower shelves of the
mounting clips. (Figure B)
Continue to kit assembly
(Figure A)
ISO DIN radio provision
1.
2.
3.
4.
5.
6.
7.
(Figure B) (Figure A)
3
Kit Assembly
Cut and remove shaft supports from the faceplate.
Snap faceplate into the radio housing.
Slide the aftermarket radio into the back
of the kit.
Slide the ISO-DIN brackets onto the housing
legs and align the holes in the brackets with the
holes in the radio.
Mount the brackets to the radio with (4) 5mm
flat-head screws supplied ("A").
Mount the brackets to the top of the Housing legs
with (2) #6 self-tapping screws ("B").
Locate the factory wiring harness in the dash.
Metra recommends using the proper mating
adapter from Metra or AXXESS. Re-connect the
negative battery terminal and test the radio for
proper operation.
Reassemble dash in reverse order of disassembly.
"B"
"A"
"B"
"A"