Ocultar thumbs Ver también para 99-3012G-LC:

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

INSTALLATION INSTRUCTIONS FOR PART 99-3012G-LC
Chevy Sonic 2012-up
KIT FEATURES
• DIN and DDIN head unit provision
• Painted silver to match factory dash
• AXXESS Interface included
• Provides accessory (12 volt 3 amp) and retained
accessory power
• Retains all warning chimes
KIT COMPONENTS
• A) Radio trim panel • B) Radio brackets • C) Pocket • D) (4) #8 x 3/8" Phillips truss-head screws
• E) Panel clips • F) Interface • G) 4-pin to 44-pin harness
A
B
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • Interface Included
Antenna Adapter: • 40-EU55 multi-use antenna adapter
METRA. The World's best kits.
APPLICATIONS
99-3012G-LC
C
D
F
G
1-800-221-0932
Dash Disassembly
– Chevrolet Sonic 2012-up...................................... 2
Kit Assembly
– ISO DIN radio provision with pocket ...................... 2
– Double DIN radio provision ................................... 3
Interface Installation
– Wire connections ..............................................3-4
TOOLS REQUIRED
E
• Panel removal tool • Phillips screwdriver
• Socket Wrench
CAUTION: Metra recommends disconnecting the
negative battery terminal before beginning any
installation. All accessories, switches, and especially
air bag indicator lights must be plugged in before
reconnecting the battery or cycling the ignition.
NOTE: Refer to the instructions included with the
aftermarket radio.
metraonline.com
Table of Contents
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION

Publicidad

Tabla de contenido
loading

Resumen de contenidos para Metra 99-3012G-LC

  • Página 1 INSTALLATION INSTRUCTIONS FOR PART 99-3012G-LC APPLICATIONS Table of Contents Chevy Sonic 2012-up 99-3012G-LC Dash Disassembly – Chevrolet Sonic 2012-up........2 KIT FEATURES Kit Assembly • DIN and DDIN head unit provision • Painted silver to match factory dash – ISO DIN radio provision with pocket ...... 2 •...
  • Página 2: Dash Disassembly

    5. Locate the factory wiring harness (Figura B) and antenna plug in the dash. Metra recommends using the proper mating adapters from Metra and/or AXXESS. Test the unit for operation. 6. Mount the new radio assembly into the dash, snap-in the radio panel,...
  • Página 3 2. Install the four included panel clips Note: Refer to the instructions included with the aftermarket radio onto the appropriate locations of Use Metra’s 99-3012G to retain ONSTAR, steering wheel audio controls, or control the radio trim panel. of the vehicle customization menu.
  • Página 4 INSTALLATION INSTRUCTIONS FOR PART 99-3012G-LC Wire connections to be made Installing the Interface 1. Plug the interface into the vehicle and into the radio. 2. To initialize the interface, turn the ignition on and wait for 30 seconds, then turn the ignition back off, and on again.
  • Página 5: Herramientas Requeridas

    INSTRUCCIONES DE INSTALACIÓN PARA LA PIEZA 99-3012G-LC AplicAciones Indice Chevy Sonic 2012 y mas 99-3012G-LC Desmontaje del tablero – Chevy Sonic 2012 y mas ........2 cArActerísticAs del kit Ensamble del kit • DIN y DDIN prestación unidad principal – Provisiones de unidad central ISO DIN ....3 •...
  • Página 6: Desmontaje Del Tablero

    (Figura B) 5. Ubique el arnés del cableado de fábrica en el tablero. Metra recomienda usar el adaptador de acoplamiento adecuado de Metra o AXXESS. Vuelva a conectar el terminal negativo de la batería y...
  • Página 7: Conexiones De Cables Que Se Deben Hacer

    Nota: Remítase a las instrucciones incluidas con el radio de postventa. 2. Instale los cuatro ganchos incluidos del panel en los lugares Utilice Metra de 99-3012G para retener ONSTAR, controles de audio en el volante, o el control correspondientes del panel de la del menú de personalización de los vehículos.
  • Página 8 INSTRUCCIONES DE INSTALACIÓN PARA LA PIEZA 99-3012G-LC Conexiones de cables que se deben hacer Instalación de la Interfaz 1. Conecte la interfaz en el vehículo y en la radio. 2. Para inicializar la interfaz, apague la ignición y espere 30 segundos, luego gire la llave de encendido apagado, y volver.

Tabla de contenido