Kit Assembly; Important - Metra 99-7313 Instrucciones De Instalación

DIN radio provision with pocket
1. Remove the metal DIN sleeve from the
aftermarket radio.
2. Slide the sleeve in the radio housing and then
secure by bending the metal locking tabs down.
(Figure A).
3. Slide the radio back into the sleeve until it clicks
in. (Figure B)
4. Locate the factory wiring harness and antenna
connector in the dash and complete all necessary
connections to the radio and climate controls.
Metra recommends using the proper mating
adapter from Metra or AXXESS. Re-connect the
negative battery terminal and test the radio for
proper operation.
5. Reassemble the dash in reverse order of
disassembly.
METRA. The World's best kits.
Installation instructions for part 99-7313

Kit Assembly

(Figure A)
(Figure B)
™ metraonline.com

IMPORTANT

If you are having difficulties with the
installation of this product, please call our
Tech Support line at 1-800-253-TECH.
Before doing so, look over the instructions a
second time, and make sure the installation
was performed exactly as the instructions
are stated. Please have the vehicle apart
and ready to perform troubleshooting steps
before calling.
K
NOWLEDGE IS
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP
certified technicians
© COPYRIGHT 2004-2016 METRA ELECTRONICS CORPORATION
P
OWER