Publicidad
Idiomas disponibles
Idiomas disponibles
R R E E A A R R P P A A N N E E L L
19
21
23
20
22
( ( 1 1 9 9 ) )
R R E E M M O O T T E E S S W W I I T T C C H H
A 1/4" connector is provided for connection of the footswitch. The footswitch cable should be
connected before the amp is powered up. See the FOOTSWITCH section of this manual for explanation
of footswitch operation.
( ( 2 2 0 0 ) )
E E F F F F E E C C T T S S L L E E V V E E L L S S W W I I T T C C H H
Selects the effects loop operating level: -10 dBV (0.3V RMS) when "Down" and -1.4 dBV (850 mV) when
"Up."
( ( 2 2 1 1 ) )
E E F F F F E E C C T T S S S S E E N N D D
Output for supplying signals to external low-level effects or signal processing equipment.
( ( 2 2 2 2 ) )
E E F F F F E E C C T T S S R R E E T T U U R R N N
Input for returning signals from external low-level effects or signal processing equipment.
( ( 2 2 3 3 ) )
P P R R E E A A M M P P O O U U T T
The preamp out can be used to route the amplified signal from the preamp to a mixing console, tape
recorder, etc. Connect the preamp output to line-level inputs of other equipment using a high-quality
shielded cable. This patch does not affect operation of the amplifier.
( ( 2 2 4 4 ) )
P P O O W W E E R R A A M M P P I I N N
Used to connect line-level signals to the Supreme XL's power amplifier section. Connect the power amp
input to line-level output of other equipment using high-quality shielded cable. This patch disconnects
the Supreme XL preamp section from the power amp section.
( ( 2 2 5 5 ) )
D D A A M M P P I I N N G G
This three-position switch allows for adjustment of the damping factor of the power amplifier. Damping
is the ability of an amplifier to control speaker cone motion after the signal disappears. A higher
damping factor (TIGHT) reduces cone vibration more quickly than a lower damping factor (LOOSE). If
the Damping switch is changed, the volume level of the amp will also change and may require re-
adjustment of the Master Volume (3).
25
24
26
27
7
29
28
Publicidad
