JANE Balance Manual Del Usuario página 34

Main use options:
1 - Rear facing
For babies from 40 to 60 cm with the insert.
For children from 60 to 105 cm in height and a maximum weight of 18 Kg without the insert.
Install the seat with ISOfix anchors and the anti-rotation leg.
The child is secured with the 5-point harness fitted in the seat.
2 - Forward facing
For children of 76 to 105 cm tall and with a maximum weight of 18 kg.
Do not use in the forward facing position is the child is less than 15 months old.
Install the seat with ISOfix anchors and the anti-rotation leg.
The child is secured with the 5-point harness fitted in the seat. The BALANCE safety seat should preferably
be installed on the rear seat of the vehicle. Before installing the safety seat, make sure that the vehicle seat
where you are going to install it is i-Size, or that it is fitted with ISOfix anchors and that your vehicle is on the list
of compatible vehicles.
Extract the ISOfix anchors (6) by turning the handle (9) on the side of the base. The anti-rotation leg (12) will
1.a
unfold due to BALANCE.
Guide both anchors towards the connectors and press until both sides are locked, two green signals on the
1.b
base (8) will show that both sides are correctly anchored. If one or both of the signals are red, repeat this step.
Turn the handle (9) anti-clockwise to fit the safety seat firmly against the backrest of the vehicle seat. 1.c
Pull the leg lock (12b) and extend it until it makes contact with the floor of the vehicle. The signals on the foot of
the leg (12a) will turn green. 1.d
Release the leg lock and extend the leg manually until it locks again. The lock signal will turn green. 1.e
34
EN