Paslode 901000 Manual De Instrucciones página 20

Ocultar thumbs Ver también para 901000:
Tabla de contenido

Publicidad

Troubleshooting
Normal Stage of Operation
S
Y
M
P
T
O
M
Tool operates properly, but fasteners do not
drive fully.
Tool operates properly, but fasteners are
sometimes over-driven, and sometimes
under-driven.
Tool operates, but no fastener is driven.
Tool operates erratically or appears to be
losing power - tool indicator light is green.
Tool operated and drove fasteners, but
driver blade did not return to up position.
Combustion chamber does not drop after
tool cycles.
If tool will not operate after following the above service directions, return the tool to an authorized Paslode
representative for service.
For the nearest Paslode
For factory direct service call 1-800-447-3830.
For technical support call 1-800-222-6990 or visit our web site at www.paslode.com.
To purchase parts, visit our website at www.itwconstructionparts.com.
18
P
O
S
Work-contacting element requires adjustment.
Fuel cell is low.
There may be loss of seal in combustion
chamber.
Work-contacting element is not adjusted
properly for the type of material being
fastened.
Wrong fasteners being used.
Follower not properly engaged behind fastener
strip.
Jammed fastener.
Fuel cell is low.
Spark plug wire is loose.
Air filter is dirty, causing tool to overheat.
Tool is dirty.
Built-up dirt and debris on driver blade or in
nosebore.
Tool is dirty.
Work-contacting element is bent, or is dirty.
representative call 1-800-682-3428.
®
An Illinois Tool Works Company
888 Forest Edge Drive
Vernon Hills, Illinois 60061
www.paslode.com
S
B I
L
E
P
R
O
B
L
E
M
S
Adjust work contacting element.
Check fuel cell and replace as required.
Press work contacting element against
workpiece for one minute. Pull trigger. If
fastener does not drive, there is a leak that
requiresservice.
Adjust work-contacting element. Readjust
as required when material density or
thickness of material being fastened
changes.
Use only fasteners meeting Paslode
specifications. Check fasteners and
applications section for fastener types and
sizes recommended for use in Cordless
tool.
Position follower behind fastener strip and
engage strip.
Clear jam.
Check fuel cell.
Check spark plug wire.
Remove air filter and clean. Use soap and
water to remove stubborn debris.
Clean tool.
Clean driver blade and nose bore with
degreasercleaner.
Clean tool.
Clean track or replace work-contacting
element.
S
E
R
V
C I
E
®
®

Publicidad

Tabla de contenido
loading

Tabla de contenido