Battery And Charging System; Inserting Battery; Important - Paslode 901000 Manual De Instrucciones

Battery and Charging System

Inserting Battery

1. Load the battery, contacts first, into the Cordless Brad
Nailer.
2. Push battery fully forward into its locked position.
3. To remove battery, push down on locking tab and slide
battery out.
NOTE: If battery is left in tool for an extended period, the
battery will discharge completely and will require recharging.
IMPORTANT: Should your battery terminals become
corroded and cause poor electrical contact, clean the
terminals using a soft cloth.
8
Clean the
contacts
Battery Indicator Light
On the right side of the handle is a small plastic lens. This
is the battery indicator light. When you insert a fully-charged
battery into the tool, you will see a blinking green light. If the
indicator light blinks red, recharge the battery.
BATTERY INDICATOR LIGHT