Integrated Solution; Dell|Emc San Gateway Solution - Dell PowerVault NX1950 Guia De Instalacion

If you change any properties in the list below, run the Dell Storage
Initialization Wizard by clicking the Run Dell Storage Initialization
Wizard link from Dell Management Tools in the PowerVault NX1950
Management Console.
• Computer name
• Administrator account name
• Domain

Integrated Solution

The Dell Storage Initialization Wizard performs the following steps
to configure your storage solution:
1 Prompts you to change the array name.
2 Configures the PowerVault MD3000 storage array for a single-node
or a multiple-node cluster.
3 Configures the PowerVault NX1950 storage systems for a single-node
or a multiple-node cluster.

Dell|EMC SAN Gateway Solution

NOTE:
If you are running the Dell Storage Initialization Wizard for the first time,
you will be prompted to install EMC Navisphere
Registering PowerPath for the SAN Gateway Solution
NOTE:
A license key is required for a host connected to CX-series storage
arrays. You do not need a license key if the host is connected to AX-series
storage arrays.
If you have purchased EMC PowerPath
on the license key card. To add the license key:
1 Click Start→ Programs→ EMC, and then select PowerPath Licensing
Tool from the PowerPath Program group.
2 Enter the license registration key, select Add, and then click OK.
After initializing the storage array through the EMC Storage System
Initialization Wizard, the array will reboot.
NOTE:
Do not perform any operations using the Dell Storage Initialization
Wizard until the storage arrays have successfully rebooted.
24
Completing the Configuration
®
Agent.
®
, the license registration key is