Switching To Timer Mode (Mode Menu) - ProMinent gamma/ L Instrucciones Suplementarias De Funcionamiento

Switching to timer mode (MODE menu)

30
4 Switching to timer mode (MODE menu)
NOTICE
• You cannot set up or program the pump in this mode!
Select another operating mode.
• The "AUTO" operating mode can stand for the "PROFIBUS
gamma/ L devices. It is not possible to change some pumps, however, because the
controller software never contains both the program parts for the timer and for the
"PROFIBUS ® controller at the same time.
Once you have selected all settings and would like to control the pump via the timer, select the "AUTO"
operating mode:
Analog
Manual
Auto
Analog Manual Contact Batch
P
Permanent
display
Press for 2 Seconds
Set to "MODE" and
Set to "AUTO" and
The timer software now creates the pump status that you would have had at precisely this time, if you had
been in "AUTO" mode all the time.
Appendix
Remarks
Status when the programmed pump is reconnected to the power supply:
The timer software creates the status of the pump that you would have had at precisely this time, if you had
not disconnected from the power supply.
Effective settings after switching between AUTO and other modes:
The mode settings are stored and are reapplied when the respective mode is selected again.
Memory duration of your program:
The pump stores its programming for up to 10 years, the time for up to 3 months without power supply,
provided the pump has been connected to the power supply for 24 hours.
- Analog
- Manual
Contact
P - Contact
Batch
- Batch
Auto
- Auto
press
press. . Ready!
® control mode" in other
ProMinent ®