Check Program Lines (Show) - ProMinent gamma/ L Instrucciones Suplementarias De Funcionamiento

Sorting sequence
1. Criterion for sorting
Events to be enabled
TIM
CNT
AUX
V 0
V 1
...
...
V12
Tab. 4: Sorting sequence for the program lines
* Only when enabling a TIME event
Sequence of displays
ProMinent ®
2.2

Check program lines (SHOW)

You can check the individual program lines using SHOW Select the required program lines in accordance
with the line number using the arrow keys. As the timer-software automatically orders the program lines,
the numbering of the program lines may change when you alter a program.
After programming has been completed the timer software automatically incorporates all newly programmed
program lines into the correct order
The first criterion for sorting is the type of event to be enabled (sequence see Tab. 4). TIM program lines are
arranged one below the other after the switch time and in order of the length of the cycle. The fourth criterion
for sorting is the type of action (compare also the programming examples at the end of these instructions).
Solely timed timer programs also proceed in this order.
2. Criterion for sorting*
Switching time
mm (minute)
hh (hours)
www (weekday)
Since a whole program line is too long for the LCD display the parts of the program lines are displayed in an
automatically changing sequence.
Events to be Time
enabled information*
* Extended time information when enabling TIME event, see Fig. 2
Fig. 1: Sequence of displays within a program line
Explanation of the placeholders in lower case see Tab. 5
Example:
Settings for the "Timer" function (SET-menu)
within the other program lines.
3. Criterion for sorting*
Cycle
HOUR
DAILY
WORK
W'END
WEEK
2WEEK
Actions Specification
4. Criterion for sorting
Actions
MAN
BATCH
CNTCT
ANALG
FREQ
REL. 1
REL. 2
V: xx
27