Support Bracket And Charge - Gima SUPERVEGA EVO Manual De Istrucciones

GB
TAB. II – WRITTEN SIGNALS / BUTTON LED SIGNAL
Button LED signal / written
signal
ON/OFF button
Proximity Button
CHA
Small three-digit number
(000)
Bar-graph (arc bar-graph)
Large three-digit number
(000)
PROXIMITY FUNCTIONS:

Pressing the "Proximity" (Lights BLUE LED) is activated on / off the motor by an infrared proximity sensor that detects the
presence of the operator's hand from a few inches away. This allows the operator to use the device without touching or focus
on pressing the button.
 The on / off button is also active with the function of proximity inserted and can be used as an alternative.

To remove the "Proximity" you have to re-press the button.
The "Proximity" is retained, or if it was active before power off, then on again to return to this, but if it was not active will remain
disabled. The function set to power down the card after 2 minutes after turning off the engine if it is not then on again.
The unwanted approach of the hand to the Proximity sensors causes the device to switch off. To reactivate the
function, place the hand close to the sensors.
NOTE: It is up to the end user to activate or deactivate the Proximity sensor. With the Function off, the device is activated/deactivated
by pressing the ON/OFF key.

SUPPORT BRACKET AND CHARGE

The device is supplied with support bracket, therefore, the SUPERVEGA EVO suction unit can be fixed to the rescue means, in
compliance with the standards of reference. This bracket is equipped with electrical cable connected to the 12V
supply source of the ambulance and allows the internal battery of the suction unit to be charged.

The bracket must be installed in compliance with the indications provided in this manual. Failure to comply with such
warning may compromise the conformity to standard EN 1789 (design and construction of medical vehicles) and
significantly reduce the safety of the medical device;

Never alter mechanical, electrical, and structural parts of the bracket. These interventions make the device dangerous and,
therefore, they preclude its use;
The support bracket of the SUPERVEGA EVO device consists of a plastic part (ABS) and a seal hook, which allows the suction unit
to be fixed safely and easily. The figure below shows the bracket complete in all its parts.
Function
Power on
Switch the ON/OFF key
Displays the battery charge
status
Displays the voltage of the
device if in charge phase or it
displays the full scale of the
bar-graph.
It displays the trend of the
negative pressure or of the
charge status
It displays the negative
pressure set by keys "up"
and "dw"
Colour
Green
Blue
Fixed white back-light
and progressive
activation of the bar-
graph
Fixed white or green
back-light depending on
whether external power
supply or battery and
progressive activation of
the bar-graph are used.
Progressive activation of
the bar-graph (black)
Fixed white or green
back-light depending on
whether external power
supply or battery is used.
26
Position
Near the front panel key
LED located above the
"Proximity" key
Central in digits of large
dimensions
Sideways in small digits
Arc-shaped in the middle of the
screen
Central in digits of large
dimensions
power