Operation On-Site - Mettler Toledo M400 FF Guía De Configuración Rápida

6

Operation On-Site

6.49
B
25.0
B
B 4 61 . 5
B 0 .0
Left: Measurement mode (example), Right: Edit mode (example)
1 Channel information
A: Analog sensor is connected.
B: ISM sensor is connected.
H: Transmitter is in Hold mode. Refer to the Operation Manual of the transmitter.
2 1st line (a), standard configuration
3 2nd line (b), standard configuration
4 3rd line (c), Measurement mode: The screen depends on configuration.
Edit mode: Navigation through the menu or editing parameters
5 4th line (d): Measurement mode: The screen depends on configuration.
Edit mode: Navigation through the menu or editing parameters
6 If a u is displayed, you can use the c or the  key to navigate to it. If you click [ENTER] you will
navigate backwards through the menu (go back one screen).
You can configure the information shown on the display for each line. By default in the mea-
surement mode no values are shown in the third and in the fourth line of the display.
For configuration refer to the Operation Manual of the transmitter.
en
38
pH
°C
d DLI
d TTM
6.49
B
25.0
B
Channel Select = ISM
Parameter = Auto
pH
°C
u