Replacing The Feed Rolls For Tray - Xerox Phaser 5335 Guía De Instalación Del Kit De Mantenimiento

3. Push the tabs on both sides of the retard
roll assy in the inward directions.
While rotating the retard roll assy to the
back, remove the roll from the printer.
4. Install the new retard roll assy in the printer,
rotating the roll to the back so that the
projections on both sides of the roll are
inserted into the guides on the printer.
Push down the retard roll assy so that the
tabs on both sides are inserted securely
into the printer.
5. Close the top cover and the front cover.

Replacing the Feed Rolls for Tray 2

1. Pull out the tray until it stops. Hold the tray
with both hands, lift it up slightly, and then
pull it out completely.
2. Pinch the tabs on both sides of the roll
cover to release the lock, and open the roll
cover.
7