Xerox Phaser 5335 Guía De Instalación Del Kit De Mantenimiento página 9

Ocultar thumbs Ver también para Phaser 5335:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8.
Pull down on the tab of the feed roll on the
front shaft to release the feed roll and slide
the feed roll off of the shaft
Note
• If you cannot see the tab of the feed roll, rotate the
feed roll until the tab can be seen.
9.
Remove the feed roll from the back shaft in
the same manner.
10. Install one of the new feed rolls on the back
shaft from the side with the short tab first.
11. Align the short tab of the feed roll with the
indentation on the shaft, and push the feed
roll firmly onto the shaft.
12. Install the other new feed roll on the front
shaft in the same manner.
13. Push the tray all the way into the printer.
Important
• When inserting the tray, be careful not to get your
fingers caught between the tray and the printer or
another tray (if the optional sheet feeders are
installed).
The installation of the maintenance kit is now complete.
long tab
short tab
9

Publicidad

Tabla de contenido
loading

Tabla de contenido