Metz SCA 3402 M10 Manual Del Usuario página 14

to save. Saving will occur automatically after 5s if
the setting disk is not pressed. After saving the
symbol "TTL" will stop flashing.
For system-inherent reasons the flash mode
with secondary reflector is not supported by
the70 MZ-5... in i-TTL-flash mode. Depen-
ding on the camera type, the triggering of the
camera will be blocked if a second reflector
is activated.
mecablitz 76 MZ-5 digital
• For the i-TTL flash mode press the button
"Mode" repeatedly on the flash unit until "Mode"
with the possible flash modes is shown the dis-
play.
• Then set the flash mode TTL with the buttons UP
and DOWN . The operating mode selected is
highlighted with a bar.
• For the i-TTL BL flash mode set the TTL BL flash
mode with the buttons UP
In case TTL BL is not yet shown in the dis-
play: first set the flash mode TTL with the
buttons UP G and DOWN. "TTL BL" will then
be shown in addition in the display. Next sel-
ect "TTL BL" with the buttons UP
DOWN .
• Press the button "Return"
switches back to the normal display. After c. 5s
the display automatically returns to normal if the
button "Return"
For the i-TTL-flash mode TTL is shown in the dis-
play. For the i-TTL BL flash mode
shown in the display.
14
and DOWN
is not pressed.
.
and
. The display
TTL BL is