Mounting The Sca Adapter - Metz SCA 3402 M10 Manual Del Usuario

2. Mounting the SCA adapter

All units involved must be switched off before
mounting or removing the SCA adapter
on/from the flash unit or the flash unit on/from
the camera. Should your camera have a built-
in foldable flash unit make sure that it is com-
pletely folded down during operation with an
external flashgun!
For mounting or removing the SCA adapter on/from
the individual flash units please refer to the detai-
led description in the operating instructions of the
flash unit concerned..
Mounting the flash unit with SCA adapter on
the camera
• Screw the knurled nut of the SCA adapter as far
as possible towards the head of the adapter
case. The locking pin in the adapter shoe is now
fully retracted into the case.
• Slide the adapter into the camera's flash shoe.
• Screw the adapter's knurled nut as far as possi-
ble towards the camera case to clamp the adap-
ter in position. If the camera does not have a
locking hole the spring-loaded locking pin retrac-
ts into the adapter case so that it does not dama-
ge the surface.
7