Ttl Flash Bracketing „Fb; Auto Flash Mode; Manual Flash Mode - Metz SCA 3402 M10 Manual Del Usuario

5.4 Auto flash mode

A sensor inside the flash unit controls the light out-
put in the auto flash mode „A". When the amount
of light required for correct exposure has been rea-
ched, the flash unit's electronic system automati-
cally cuts off the flash. Correct exposure confirma-
tion "ok" is then given on flash unit (see 6.4).
mecablitz 44 MZ-..., 45 CL-4 digital, 54 MZ-... ,
70 MZ-... and 76 MZ-5
Set auto mode „A" on the flash unit (see operating
instructions for the given flash unit).
The flash unit automatically adjusts its auto wor-
king aperture to the f-stop set on the camera.
Ensure that the subject lies within the maximum
flash range (indicated on the flash unit).
• 45 CL-4 digital: Continue depressing the "Mode"
key until "A" and "
tor window. When the camera's shutter release
is lightly touched the flash unit automatically
takes over the data for the aperture and ISO set-
ting from the camera. The values for auto wor-
king aperture and ISO manually adjusted on the
flash unit are irrelevant in this context.

5.5 Manual flash mode

In the manual flash mode „M" the light is not con-
trolled by a sensor. Instead the flash unit operates
with full power or a partial light output.
mecablitz 44 MZ-..., 45 CL-4 digital, 54 MZ-... ,
70 MZ-... and 76 MZ-5
The camera automatically transmits the adjusted f-
stop to the flash unit. Select the appropriate aper-
ture/light output combination (camera/flash unit) to
"appear on the indica-
17