Forward-Facing Installation With Vehicle Seat Belts - Graco READY RIDE Manual De Instrucciones

FORWARD-FACING
WARNING
LATCH belt MUST be stored when
using vehicle seat belt to install
child restraint.
1
Store LATCH belt by attaching to connectors
through rear-facing openings
(see page 31, fig. j
side (fig. a).
LATCH
by pulling adjustment belt.
2
Adjust car seat to upright position (see fig. b
and page 25, fig. a
Place forward-facing
3
(fig. c).
18
INSTALLATION WITH VEHICLE SEAT BELTS
4
Press down firmly in center of child restraint to
child restraint (fig. d).
5
belt MUST stay tight.
If not secure, see "Vehicle Seat Belts" page 32.
6
hardware (B) and tighten adjustment belt to
Storage", page 37.
Belt must lay flat and not be twisted.
child.
(fig. e)
(A) to anchor
(fig. f)