Reversing Operation; Reverse Control Switch - Alliance Laundry Systems JT37CE Instalación Operación Mantenimiento

PUSH-TO-START
BUTTON

REVERSING OPERATION

This tumbler is equipped with a second motor and
additional controls to reverse the direction of the cylinder
rotation. The main reason for this option is to prevent
tangling of large pieces and minimize wrinkling.

REVERSE CONTROL SWITCH

A simple "on-off" switch is placed in the control panel
area so the operator can choose reversing or non-
reversing operation. The switch is wired into the reverse
control time circuit in such a way that the cylinder will
always turn clockwise (as viewed from the front of the
dryer) when the reverse control switch is actuated for
"non-reversing" operation. If the cylinder is turning in
the wrong direction when the switch is actuated, it will
continue for a few seconds and then start up in the proper
direction.
52
COOLING
INDICATOR
PUSH
COOLING
TO
START
10
5
COOLING
TIMER
SELECTOR
DRYING INDICATOR
DRYING
50
15
40
60
0 0
30
10
20
Figure 23
IMPORTANT: After any electrical maintenance is
done, make sure that the blower motor is turning
clockwise as viewed from the front. Then set the
reverse control switch to "non-reversing" and note
that the cylinder turns constantly clockwise as viewed
from the front of the tumbler. If not, interchange L1
and L2 power leads to the reverse drive motor.
DRYING
TIMER
SELECTOR
T216IE3D
70369801