Erreka VIVO-M201 Guía Rápida De Instalación Y Programación página 10


When using a single
operator, connect it to
cable connectors G1, G2
and G3 (operator A1).
DL2: receiving RSD radio signal
DL3: programming enabled
DL4: gate opening
DL5: gate closing
PUL1: close mini-pushbutton
PUL2: open mini-pushbutton
T: earth connection
Turning direction: check operation using the mini-pushbuttons PUL1 (close) and PUL2 (open). If the turning direction
of any operator is not correct, interchange the cables connected in cable connectors G1 and G2 or G4 and G5.
10
General connections
FCA2 COM FCC2
P1 P2 P3 P4 P5 P6 P15 P14 P16
ST1 FT1 ST2 FT2 FCA1
ST1
FT1
ST2
FT2
VIVO-M201: 230Vac
VIVO-M201M: 125Vac
A1 operator connections:
G1
G2
G3

When pressing PUL1 (close), DL5 lights up and A1 G2-G3 and A2 G5-G6
cable connectors are enabled.

When pressing PUL2 (open), DL4 lights up and A1 G1-G3 and A2 G4-G6
cable connectors are enabled.
SW2 Functions during programming (DIP1=ON)
DIP1=ON: programming enabled (DL3 lights up)
DIP1=ON and DIP2=ON: total open/close programming
DIP1=ON and DIP3=ON: pedestrian open/close programming
DIP1=ON and DIP4=ON: total opening radio code programming
DIP1=ON and DIP6=ON: pedestrian opening radio code programming
SCA
P7 P8 P11 P12 P22 P23 G7 G8 G9 G10
Courtesy
24Vac Lamp.
FCC1 STOP LOCK
Light
VIVO-M201: max 2.300W
VIVO-M201M: max 1.250W
open
close
common, grey
G4 G5 G6 G1 G2 G3
N L
POWER
MOTOR2 (G2-G1-COM) MOTOR1 (G2-G1-COM)
L
N
G4 G5 G6 G1 G2 G3
VIVO-M201: 230Vac
VIVO-M201M: 125Vac
A2 operator connections:
G4 open
G5 close
G6 common, grey
VIVO-M201:
230Vac/50Hz
VIVO-M201M:
125Vac/60Hz
P176Z