Maintenance And Repair; Battery Replacement - Amprobe CO2-100 Manual De Uso

MAINTENANCE AND REPAIR

If there appears to be a malfunction during the
operation of the meter, the following steps should be
performed in order to isolate the cause of the problem.
1. Check the battery. Replace the battery
immediately when the "
the LCD.
2. Review the operating instructions for possible
mistakes in operating procedure.
Except for the replacement of the battery, repair of the
meter should be performed only by a Factory Authorized
Service Center or by other qualified instrument service
personnel. The front panel and case can be cleaned with
a mild solution of detergent and water. Apply sparingly
with a soft cloth and allow to dry completely before
using. Do not use aromatic hydrocarbons or chlorinated
solvents for cleaning.

BATTERY REPLACEMENT

1. The meter is powered by either 4 AA batteries or a
DC adaptor (9V/1A output).
2. When battery voltage gets low, "
will appear on the LCD (Fig.6). And beeper sounds.
The CO2 sensor can't work under low voltage, so it
beeps to indicate failed CO2 measurement and the
readings won't be displayed. Please replace with
fresh batteries or connect with an adaptor.
" symbol appears on
10
" and "Lob"