Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1) The salt and rinse aid indicator lights never come on while a washing programme is running even if
filling with salt and/or rinse aid is necessary.
The digital display
The digital display indicates:
• the level of hardness to which the water
softener is set,
• the number corresponding to the washing
programme,
• the approximate remaining time of the run-
ning programme,
• activation/deactivation of the rinse aid dis-
penser ( ONLY with 'Multitab' function ac-
tive).
• the end of a washing programme (the dig-
ital display shows a zero),
• the countdown for the delay start,
• fault codes concerning malfunction of the
appliance,
• activation/deactivation of the audible sig-
nals.
Delay start button
You can delay the start of the programme for
between 1 and 19 hours.
Refer to 'Select and start a washing pro-
gramme' chapter for the set of this function.
Programme selection buttons
Press one of these buttons until the display
shows the number of the desired pro-
gramme. Refer to 'Washing programmes'
chart for details.
Save energy button
This function decreases the temperature in
the drying phase. Energy saving is between
10% and 25%.
Dishes can be wet at the end of the pro-
gramme. In this condition we recom-
mend, to open the dishwasher door and
keep it ajar and let dishes dry naturally.
This function can be set with all washing pro-
grammes. The related indicator light comes
on when you press the button.
The save energy function has no effect on
some programmes. Refer to 'Washing pro-
grammes' for the list of programmes where
save energy has or not effect.
Indicator lights
Comes on when a washing programme has
ended.
Multitab button
Set this function when you use combi deter-
gent tablets (3 in 1, 4 in 1, 5 in 1, etc.).
Refer to 'Multitab function' chapter.
Cancel button
With this button you can cancel a washing
programme or a delay start in progress.
Function buttons (A, B and C)
The following functions can be set using
these buttons:
• setting the water softener level,
• activation/deactivation of the rinse aid dis-
penser when Multitab function is active,
• activation/deactivation of the audible sig-
nals.
Setting mode
Press the on/off button. If the lights of the
programme selection buttons come on and
the digital display shows 2 horizontal bars,
the appliance is in setting mode.
Always remember that when performing
the following operations:
– selecting a washing programme,
– setting the water softener level,
– activating/deactivating the rinse aid,
– activating/deactivating the audible
signals,
the appliance MUST be in setting mode.
Press the on/off button. If the lights of the
programme selection buttons come on and
the digital display shows the time duration (in
minutes) of a programme, this means that the
last performed or selected programme is still
set. In this case, to return to setting mode,
the programme has to be cancelled.
To cancel a set programme or a pro-
gramme in progress
• Press and hold the cancel button until the
digital display shows 2 horizontal bars. The
programme has been cancelled and the
appliance is now in setting mode.
electrolux 5
Publicidad
Tabla de contenido
